Hardware setup – Asus P3V133 User Manual

Page 35

ASUS P3V133 User’s Manual

3. HARDWARE SETUP

Connectors

3. H/W SETUP

8. IDE Device Activity LED (2-pin IDELED)

This connector supplies power to the cabinet’s IDE device activity LED. Read
and write activity by devices connected to the Primary or Secondary IDE con-
nectors will cause the LED to light up.

P3V133 IDE Activity LED

TIP: If the case-mounted LED does not light,
try reversing the 2-pin plug.

IDELED

P3V133

9. Wake-On-Ring Connector (2-pin WOR)

This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.

IMPORTANT:

This feature requires that the PWR UP On Modem Act Power

Up Control is set to Enabled (see Power Management Setup under BIOS SETUP).

P3V133 Wake-On-Ring Connector

WOR

Pin 2 PIXRI#

Pin1 Ground

P3V133