Catskill Craftsmen 43017 - Manual (Page 4)

1 1/4” Phillips Flat Head #8 Screw (12)
4 Used in this step
Attach a table top stick to the
top of each side panel using
1 1/4” #8screws. The countersunk
holes (reamed out) in the
stick are positioned as in
illustration 1. Sticks should
be flush with top of panel.
STEP 1
ILLUSTRATION 1
STEP 2
A. Lay back panel flat on a smooth surface with holes up.
B. Attach side panels with 1 3/4” machine screws (bolts)
and hex nuts. After inserting bolts(s) thru the holes in the
side panels, thru the holes in the long edges of the back
panel, place a hex nut on the tip of your finger, align nut
with bolt and tighten.
C. Look ahead to step 4 which shows side panels
attached to back panel.
1 3/4” Phillips Flat Head Bolt (8)
4 Used
in this step
10-24 Hex Nut (8)
4 Used
in this step
ILLUSTRATION 2
STEP 3
ILLUSTRATION 3
Mark a Large (X) mark over each of the 4 pilot holes
in the bottom. Make marks about 1 1/2” long. These
marks will help you align the cabinet with the pilot
holes in step 4.
STEPS 3 - 13 WILL BE ACCOMPLISHED WITH THE
UNIT TOP UPSIDE DOWN ( INVERTED ), BUILDING
UPWARD TOWARD THE BOTTOM/CASTER END!
BE CAREFUL AS PART DESCRIPTIONS ARE BASED
ON AN UPRIGHT, COMPLETED UNIT!