Catskill Craftsmen 43017 - Manual (Page 10)

STEP 11
A. Stick magnet to magnet plate on right door.
B. With left door open, close the right door. The magnet should be positioned over the wooden block
on the bottom of the top front brace. Hold the magnet in place with your thumb, and open the right door.
The magnet will be in the correct position on the block.
C. Secure magnet with the two round head screws in the magnet packet. Center screws in the slots in
the magnet . This will allow adjustment later, if needed.
D. Repeat with left door.
NOTE: No pilot holes in block, as softwood!
STEP 10
A. Install doors by inserting pins in
the door tops into the holes in
the long edge top front brace.
B. Place one washer on
each of the door pins in
the door bottoms.
C. Take the bottom front
brace, align pins in door
bottoms with holes along
top long edge of brace
( are washers on pins ? )
and secure brace with
1 3/4” Machine screw/hex nuts
as before.
1 3/4” Phillips Flat Head
Machine Screw (8)
2 Used in this step
10-24 Hex Nut (8)
2 Used
in this step
2 Used
in this step
3/16” Flat Washer (2)
ILLUSTRATION 10
Magnet (2)
5/8” Pan Head Screw (4)
4 Used
in this step
ILLUSTRATION 11
Make sure you put
the washers on the
pins on the bottom
before you assemble