Step 12 – Catskill Craftsmen 1544 User Manual
Page 12
STEP 12
A. Attach the magnet plates (may be stuck to magnet!) with 1/2” Phillips flat head #4 screws to
the inside top of both doors. The countersunk hole in the plate faces out/bumps go toward wood. See
illustration 12B.
B. Attach metal door handles with 1 8/32” truss head machine screws as in illustration 12A.
C.
Stick magnet to magnet plate on right door.
D. With left door open, close the right door. The magnet should be positioned over the wooden
block on the bottom of the Top Front Brace. Hold the magnet in place with your thumb, and open the
right door. The magnet will be in the correct position on the block.
E. Secure magnet with the two round head screws in the magnet packet as in illustration 12 C.
Center screws in the slots in the magnets. This will allow adjustment later, if needed. There are no
pilot holes as blocks are soft wood.
F. Repeat with left door.
Magnet Block Assembly
Illustration 12A
Illustration 12B
Illustration 12C