Catskill Craftsmen 1538 - Manual (Page 11)

STEP 13
A. Choose at which height you want the
middle shelf to be from the two sets of holes
in the Back & Side Panels. Then tap 1” pins
into the 6 holes in the Back & Side Panels.
B. Fit the middle shelf into the cart and rest
it on the pins.
ILLUSTRATION 13
STEP 14
A. Assemble top by placing the top and the drop leaf upside down on a smooth flat surface. Install
hinges using 5/8 #8 screws. The longer part of the hinge goes on the drop leaf with the short part on
the cart top. Fasten the drop leaf supports using 5/8 #8 screws. See illustration 14B.
B. Make a large ( X ) mark over each of the 4 pilot holes in the bottom. Make marks about 1/2-1” long.
These marks will help you align the cabinet with the pilot holes in the bottom of the Top.
C. Place the Cart Top on the cabinet. Open the outside doors. Maneuver the Cart Top so that the ( X )
marks/pilot holes in the bottom of the Top align with the holes in the “L” brackets. Secure top to “L”
brackets with 5/8” #8 screws, allowing approximately 3/16” space between inside face of Knife Rack
and end of Cart Top .
ILLUSTRATION 14B
ILLUSTRATION 14A