Catskill Craftsmen 1536 - Manual (Page 5)

STEP 3
Invert table top on a smooth flat surface and
make a large (X) mark over each of the pilot
holes in the bottom. Make marks about
1 1/2” long. These marks will help you align
the cabinet with the pilot holes in step 4.
NOTE: Use holes circled on illustration.
The four outside holes are not used.
ILLUSTRATION 3
STEP 4
A. Turn the side/back assembly ( from step 2 )
upside down ( invert ) on top of the inverted table top.
B. Drop two 1 1/4” # 8 screws into the holes in
each of the table top sticks.
C. Using the (+) marks from step 3 as a guide,
insert the tips of the screws into the pilot
holes in the unit top and finger tighten.
When all 4 screws are properly aligned,
tighten down.
D. Tap two 1” pins into each side panel.
These pins will hold the bottom shelf.
See illustration5
1 1/4” Phillips Flat Head #8 Screw (12)
4 Used in this step
4 Used in this step
1” Long 3/16” DIA. Steel Pin (8)
ILLUSTRATION 4