Catskill Craftsmen 1429 - Manual (Page 6)

STEP 1
Back Assembly
1 Front Right/Back left Leg, 1 Front Left/Back Right Leg, 1 Top Back Brace, 2 Mid/Bot Back Brace,
1 Back Panel Insert.
1. Tap 3/4” pins into the ends of all the braces. The pin goes into the smaller of the two holes.
2. Lay the legs on a flat smooth surface so that the holes are oriented as shown in illustration 1.
Put bastion posts in the center hole third, fifth, and sixth holes from the tops of the legs. The holes
in the bastion posts should be oriented as shown in Illustration 1.
3. Attach the Top Back Brace, and both the Midddle & Bottom Back Braces to one of the legs
using barrel nuts and set screws, then slide in the Back Panel Insert into the grooves on the
Mid/Bot Back Braces.
4. Attach the other Leg to the braces using barrel nuts and set screws.
PIN
BASTION
POST
PIN PIN
PIN PIN
BASTION POST BASTION POST
ILLUSTRATION 1
PIN
BASTION
POST