Catskill Craftsmen 1426 - Manual (Page 4)

1 Begin assembly by laying out all of the pieces and checking against the parts list
on the previous pages.Tap Caster sleeves for the caster wheels into the bottom of
the legs using a standard hammer. Do not insert wheels yet. Assemble the Back
Assembly by laying out the Back Right and Left Legs, Back Top Bracel, Back
Center Brace, Back Bottom Brace, Back Vertical Brace and the Back Bottom
Panels as well as the necessary Bastions and 3/4” Steel Pins as shown in
Illustration 1A. Note: Back Center and Back Bottom Braces are slotted whereas
the Front Center and Front Bottom Braces are not.
Tap the 3/4” Steel Pins into place on the Back Vertical Brace and attach to the
Back Center and Back Bottom Braces. Slide one of the Back Bottom Panels into
place, and attach the leg to the Back Center and Bottom Braces using the
Bastions and 3/4” Steel Pins.
Next, attach the Back Top Brace to the leg using the Bastions.
Repeat the procedure to attach the other leg to compete Back Assembly.
Finally, tap the 1” steel pin into the center pilot hole on the Back Center Brace.
This will be used later to support the middle shelf.
BACK ASSEMBLY
Back Right Leg
Back Top Brace
Back Center Brace
Back Bottom Brace
Back
Vertical
Brace
Back Bottom Panel Back Bottom Panel
Back Left Leg
This hole not used in assembly
Caster Sleeve Caster Sleeve
Illustration 1A