American Audio V5000plus - Manual (Page 5)

1. Power Switch - This switch is used to control the units main power.
2. Channel 1 Gain Control - This rotary knob is used to control the out-
put signal of channel one. Turning the knob in a clockwise direction will
increase signal output.
3. Channel 1 Limiter Switch - This is used to activate the channels
built-in limiter. The limiter reduces the average input level when the sig-
nal begins to distort, this process is designed to reduce distortion and
protect the speakers. See limiter page 11.
4. Channel 1 Clip Indicator - This red LED will begin to flash when
channel one begins to overload (clip). At this point channel one will be-
gin to distort. Under heavy clipping activity lower the channel one gain
control to reduce the risk of damage to your speakers and amplifier. This
LED may glow when the unit has been turned off, this is normal.
5. Channel 1 Protect Indicator - The red Protect LED will begin to glow
when the channel goes into protect mode. When the channel goes into
protect mode all output for that channel will turn off. This is to protect any
speakers connected to the channel.
6. Function Indicators - These indicators detail the operating mode of
the amplifier. These LEDs will also function as a power indicator.
7. Channel 2 Protect Indicator - The red Protect LED will begin to glow
when the channel goes into protect mode. When the channel goes into
protect mode all output for that channel will turn off. This is to protect any
©American Audio® - www.americanaudio.com - V5000plus™ Power Amplifier User Manual Page 5
Front Panel Control
speakers connected to the channel.
8. Channel 2 Clip Indicator - This red LED will begin to flash when
channel one begins to overload (clip). At this point channel one will be-
gin to distort. Under heavy clipping activity lower the channel one gain
control to reduce the risk of damage to your speakers and amplifier. This
LED may glow when the unit has been turned off, this is normal.
9. Channel 2 Limiter Switch - This is used to activate the channels
built-in limiter. The limiter reduces the average input level when the sig-
nal begins to distort, this process is designed to reduce distortion and
protect the speakers. See limiter page 11.
10. Channel 2 Gain Control - This rotary knob is used to control the
output signal of channel two. Turning the knob in a clockwise direction
will increase signal output.
11. Channel 2 Signal Indicators - These green and yellow LED’s will
glow according to the average signal output.
12. Channel 1 Signal Indicators - These green and yellow LED’s will
glow according to the average signal output.
Diagram 1
1
11 12
10 9 8 7 5 4 3 2 6