Aposonic A-S3216T3 User Manual
Page 15
24/32-CH DVR Quick Start Guide
13
Input IP address, Subnet, Gateway. If using DHCP, please enable DHCP in
both the DVR and the router.
Forward IP address and port number in Virtual Server setup of the router or
virtual server. Configure the firewall to allow accessing the DVR. (If the user
has enabled the UPnP function in both the DVR and router, he can skip this
step. Please refer to the relevant chapter for more details.)
Open IE browser, input IP address, or dynamic domain name and enter. If
HTTP port is not 80, add the port number after IP address or domain name.
IE will download ActiveX automatically. Then a window pops up and asks for
user name and password. Input name and password correctly, and enter to
view.
2. Connect the DVR to Internet through PPPoE
Enter into the DVR‟s Main MenuSetupNetwork interface to enable PPPoE
and then input user name and password received from your ISP. Next, click
„Apply‟. The DVR will connect to the server and would give a confirmation
message.
If users want to utilize dynamic domain name, please apply for a domain
name in a DNS server supported by the DVR or router. Then add to the DVR or
router.
When accessing the remote interface of DVR, user can input WAN IP/domain
name
to
access
directly
(user
can
enter
into
Main
menuInformationNetwork interface to check IP address). The browser will
download Active X control
The following steps are the same as the connection way above.
450041220001 A1