WEN 2301 9.6 Volt Cordless Rotary Tool Kit - Manual (Page 14)

14
Operating Procedure
point secured in the collet, turn on the Cordless Rotary Tool and run the 415
Dressing Stone lightly against the revolving wheel point . This removes high spots
and turns up the wheel point to ensure good balance .
battery Pack Installation/Removal
• To install battery, insert charged battery in the
handle and secure with release button .
• To remove battery, press the release buttons,
located below the drill handle and gently pull the
battery pack out .
1 . Cordless Rotary Tool
2 . Battery Pack
3 . Release Button
USING THE CORDLESS ROTARY TOOL
• The first step in learning to use the Cordless Rotary Tool is to get the “feel” of it .
Hold it in your hand and feel its weight and balance . Feel the taper of the hous-
ing . This taper permits the tool to be grasped much like a pen or pencil .
• When you turn on the tool for the first time, hold it away from your face . Acces-
sories can be damaged during handing, and can fly apart as they come up to
speed . This is not common, but it does happen .
• Practice on scrap materials first to see how the Cordless Rotary Tool cuts . Keep
in mind that the work is done by the speed of the tool and by the accessory in
the collet . You should not lean on or push the tool into the work .
• Instead, lower the spinning accessory lightly to the work and allow it to touch
the area you want to cut (or sand or etch, etc .) . Concentrate on guiding the tool
over the work using very little pressure from your hand . Allow the accessory to
do the work .
• Usually, it is best to make a series of passes with the tool rather than attempt to
do all the work in one pass . To make a cut, for example, pass the tool back and
forth over the work .
• Cut a little material on each pass until you reach the desired depth . For most
work, the deft, gentle touch is best . With it, you have the best control, are less
likely to make errors, and will get the most efficient work out of the accessory .