WEN 56660 9 AMP Snow Shovel Snow Wheel Installation - Manual (Page 2)

Step 4: Remove the two Phillips screws holding the big pulley.
Step 5: Pull the shaft out of the snow wheel by pulling on the big pulley. Pay careful
attention to the flat washer on top of the bearing. Set it aside for reassembly later.
If the shaft does not pull out easily, tap on the other end (the RIGHT side of the
machine). To do this, thread the nut back on the shaft end a few turns and LIGHTLY tap
on the shaft with a hammer. Then remove the nut and try again to pull the shaft out from
the other side.