Wellsaw V20-24 - Manual (Page 3)

1
The Model V-20 WELLSAW, like other WELLSAWS, is the result of continuous development and refi nement. It’s vertical design began
with the Model W-20, introduced in 1976. Drawing on fi eld experience gained over 14 years, WELLSAW decided to launch a re-design
of the vertical saw - the new V-20 - to meet the most diffi cult operating conditions.
The new design features a 2-speed gear box, variable speed blade drive, all steel construction plus the unique rotating blade guides
which greatly increase the saw’s ability to cut very long pieces.
To fi eld test the new V-20 design, the prototype model was placed in a foundry. It was used to cut gates and runners from sand cast-
ings; a rough, abrasive, continuous operation that tested every component’s durability. The best measure of the V-20’s performance is
the fact that the foundry ordered a second V-20.
Today, the WELLSAW V-20 continues to be manufactured to conform to WELLSAW’S recognized high standards of quality and
performance. Each saw must pass a series of fi nal inspection tests, including actual metal cutting operations before it shipped. For
this saw to provide satisfactory service, it is necessary that it be properly installed, operated and maintained. This manual has been
prepared to assist you in carrying out these functions. We urge you to study this manual and follow its suggestions.
This WELLSAW is warranted against defects in material or workmanship installed or performed at the factory. Within one year from date
of purchase, we will free of charge and at our option, either repair or replace any part of this WELLSAW which our examination discloses
to be defective because of workmanship or a defect in the material. This warranty does not apply if this WELLSAW has been used in a
manner not consistent with its’ design or which has been subject to accident, alteration, abuse or misuse or which fails due to lack of care
or is the result of inadequate power supply and specifi cally does not apply to normal wear parts. THERE ARE NO WARRANTIES WHICH
EXTEND BEYOND THE DESCRIPTION OF THE FACE HEREOF.
WELLSAW shall not be liable for consequential or incidental damages suffered or incurred with respect to defective materials or work-
manship.
We do not authorize any person or representative to make any other warranty or to assume for us any liability in connection with the sale
of our products other than those contained herein. Any agreements outside of or contradictory to the foregoing shall be void and of no
effect.
All transportation costs on products or parts submitted to WELLSAW under this warranty must be paid by the user. No products or parts
are to be returned without fi rst obtaining permission.
RECEIVING AND INSTALLATION
Un-crating
Carefully remove the protective crating and skid so the saw and its parts are not marred or otherwise damaged. In the event of damage
in transit, notify the carrier and fi le a Proof of Loss Claim immediately.
Shortages
Inspect the complete shipment carefully against the itemized packing list. Make sure that all items are present and in good condition. In
the event of any shortage, notify the distributor from whom you purchased the saw and the carrier who made the fi nal delivery.
Utility Hook-Up
The use of a qualifi ed electrician is always recommended when connecting the saw to the main power supply. Electrical codes differ from
area to area and it is the customer’s responsibility to ensure that their saw complies with applicable codes. Your WELLSAW is pre-wired
at the factory for a specifi ed voltage. Always check the motor and electrical panel to ensure that they are both wired to correspond to
your electrical power supply.
PARTS ORDERING
When contacting your WELLSAW Supplier of the Company for parts or service, it is essential that you have
your MODEL NUMBER, SERIAL NUMBER and PURCHASE DATE available. Jot them down here for handy
reference.
MODEL:
SERIAL NUMBER:
PURCHASE DATE:
FULL YEAR LIMITED WARRANTY
WELLSAW MODEL V-20 HISTORY