Vitrex MIX1400 - Manual (Page 4)

06 07
Tel: +44 (0) 1253 789180 Tel: +44 (0) 1253 789180
1400W Power Mixer
Specifications MIX1400IND MIX1400
Power Supply 110V 50Hz 230V 50Hz
Motor 1400W 1400W
RPM (no load) 300-700 rpm 300-700 rpm
Number of Gears 2 2
Mixing Paddle Diameter 140mm 140mm
Weight 5.3kg 5.3kg
Q.E.P. Co UK Ltd is committed to a continuing program of
product improvement. Consequently, please be advised
that specifications, performance, appearance, and
dimensions of QEP/Vitrex products are subject to change
without notice. For more up-to-date information about our
range of products, please contact our Customer Service
Office on +44 (0)1253 789180 or your local distributor.
• For further information or advice, please
call the Vitrex Technical Helpline on
+44 (0) 1253789180.
This Power Mixer has been manufactured to a high quality standard. It is guaranteed against faulty materials and
workmanship for 12months from the date of purchase. Any claim must be accompanied by a valid till receipt as proof of purchase.
A faulty machine will either be repaired or replaced free of charge. If a direct replacement is not available, an alternative to the
same or greater value/specification will be offered.
This guarantee does not cover machine defects caused by or resulting from:
a) Misuse, abuse or neglect, b) Trade, Professional or hire use, c) Repairs attempted by anyone other than our authorised repair
agent, d) Ingress of foreign objects, substances or accident
In the unlikely event of a fault occurring, contact should be made through the Vitrex Technical Helpline +44 (0) 1253 789180
The above guarantee is only valid within the UK and does not affect your statutory rights.
The guarantor is Q.E.P. Co. UK Ltd., Everest Road, Lytham St. Annes, Lancashire, FY8 3AZ (Registered No. 04988177 England).
CARE AND MAINTENANCE
Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or maintenance.
Always store your power tool in a dry place.
If the supply cord is damaged, it must be replaced by the manufacturer,
their service agent or similarly qualified persons in order to avoid a hazard.
If a fault can not be rectified, return the mixer to an authorised dealer for repair.
Cleaning
Keep the safety devices, ventilation slots and motor housing as free of dirt and dust
as possible.
Clean the unit by rubbing it with a clean cloth or blow it clean using
low-pressure compressed air.
We recommend that you always clean the unit immediately after using it.
• Clean the unit regularly by rubbing it with a damp cloth and a little soft soap.
Do not use cleaners or solvents; these will attack the plastic parts in the unit.
You must also ensure that water cannot get into the inside of the unit.
Carbon brushes
• If excessive sparking occurs you must have the carbon brushes checked by a
qualified electrician.
•
Attention!
Only a qualified electrician is allowed to change the brushes.
Maintenance
• There are no parts fitted inside the unit that require maintenance.
For your own safety, never remove parts or accessories of the electric tool during
operation. In case of fault or damage have the electric tool repaired only by a
specialist workshop or by the manufacturer.