Admiral ADM8 10080170 - Manual (Page 13)

OPERATIONS
Remove electrical cord and literature from
recovery tank. Fill solution tank (see filling
instructions page 3-5).
STEP
1
Adjust brush to proper setting. Note: For
good operation the brush must skim the
carpet. If circuit breaker trips raise brush to
prevent damage to motor or carpet.
Plug cord into grounded outlet. Note: Be sure
dome is seated on recovery tank, and float
shut-off is installed correctly.
STEP
2
STEP
3
CORRECT
INCORRECT
1/8in
(3mm)
Turn on brush and vacuum motor switches
(“ON”=“I”). Turn on solution switch for
continuous spray or set switch to intermittent
to allow use of trigger switches.
STEP
4
SOLUTION VACUUM
CONT
INT
BRUSH
ON ON
ADMIRAL 86038230 03/16/07 3-6