Vitrex 103421 - Manual (Page 4)

06 07
POWER PRO 750 Wet Saw
Maintenance
• Always check the blade before use for
cracks or signs of damage.
• Ensure that the reservoir is filled up to the
recommended level. Do not overfill or
allow it to run dry.
• Always clean the machine after use, after
first ensuring that it is disconnected from
the mains.
• Rinse out reservoir thoroughly to remove
all sludge and wipe down outside of
machine using a cloth or sponge.
• When not in use, store the electrical cable
and plug under the machine in the space
provided.
• No other servicing is required in normal
use. No attempt should be made to repair
or replace internal components as this will
invalidate any claim whilst the product is
under guarantee.
Consumer Advice
• Do not dispose of electrical products
with your normal household waste.
• Always use recycling facilities
whenever possible.
• Additional recycling information can
be found through your local Authority
or Retailer. Slide the Mitre Guide into place on the Rip Guide. For Mitre cuts, raise the cutting table to the
required angle (15 O , 30 O or 45 O degrees)
Slacken the thumb screw and set the required
angle of cut.
Locate the appropriate lugs into the slots
provided on the inside edge of the reservoir.
Re-tighten the knob and position the tile within
the jaws of the Mitre Guide.
Place the tile against the angled table top.
Switch on the machine and while holding the tile
firmly in position, push the mitre guide steadily
along the rip guide, feeding the tile through the
cutting wheel. When the cut is complete, switch
off the machine.
Switch on the machine and feed the tile through
the cutting wheel. When the cut is complete,
switch off the machine.
Angular Cuts Mitre Cuts
Tel: +44 (0) 1253 789180 Tel: +44 (0) 1253 789180
Q.E.P. Co UK Ltd is committed to a continuing program of
product improvement. Consequently, please be advised
that specifications, performance, appearance, and
dimensions of QEP/Vitrex products are subject to change
without notice. For more up-to-date information about our
range of products, please contact our Customer Service
Office on +44 (0)1253 789180 or your local distributor.
• For further information or advice,
please call the Vitrex Technical Helpline on
+44 (0) 1253789180.
This electric tile cutter has been manufactured to a high quality standard. It is guaranteed against faulty materials and
workmanship for 12months from the date of purchase. Any claim must be accompanied by a valid till receipt as proof of purchase.
A faulty machine will either be repaired or replaced free of charge. If a direct replacement is not available, an alternative to the
same or greater value/specification will be offered.
This guarantee does not cover machine defects caused by or resulting from:
a) Misuse, abuse or neglect, b) Trade, Professional or hire use, c) Repairs attempted by anyone other than our authorised repair
agent, d) Ingress of foreign objects, substances or accident
In the unlikely event of a fault occurring, contact should be made through the Vitrex Technical Helpline +44 (0) 1253 789180
The above guarantee is only valid within the UK and does not affect your statutory rights.
The guarantor is Q.E.P. Co. UK Ltd., Everest Road, Lytham St. Annes, Lancashire, FY8 3AZ (Registered No. 04988177 England).