Vitrex 103421 - Manual (Page 3)

POWER PRO 750 Wet Saw
04 05
Assembly & Operation Operating Instructions
To fit or replace the Cutting Wheel, first take out
the removable side of the cutting table. Remove
nut and washer using the wrench provided
Place the Rip Guide on the preferred side of the
table top and line up with the rule edge to the
required measurement of the tile to be cut. When
correctly aligned, lock in place by pushing the
adjuster firmly downwards.
Position the tile on the table top.
Switch on the machine.
Maintain an even pressure, hold the tile against
the cutting guide and push steadily through the
cutting wheel. When the cut is complete, switch
off the machine.
Straight Cuts
Position blade against the black inner washer
ensuring that the directional arrow on the blade
matches that on the cutting table. Replace the
washer and nut. Do not over tighten.
Before replacing table top, fasten guard support
in the slot behind the blade opening using the
screws provided. Attach blade guard to the
support using bolt and wing nut.
Fill the reservoir to a point just below the
overflow opening at the top of the drain plug.
Replace cutting table. Check frequently during
use - do not allow the blade to run dry.
Machine Specification & Electrical Requirements
Power Supply
Motor
RPM (No load)
Maximum Sound Level*
Maximum Depth of Cut (with new blade)
Maximum Depth of Cut at 45
O (with new blade)
Mitre Cutting Angle
Cutting Angles
Machine & Accessories packed weight
*Note: If the sound intensity level exceeds 85 db (A) ear protection should be worn by the operator.
240v 50Hz
750W
2800 RPM
95 dB (A)
25mm
17mm
degrees
0 O -15 O degrees
17.5 kg
• Ensure that the mains voltage corresponds
to the instruction plate
– a single phase socket with two contacts
and an earth is obligatory.
• Use of an approved RCD circuit breaker
between the machine and the electrical
power point is highly recommended.
• To reduce the risk of unintentional starting,
make sure that the switch is in the OFF
position before plugging in.
• Repair or replace damaged or worn cable
immediately after first disconnecting from
mains supply.
• Electrical faults must only be rectified by a
qualified electrician.
The contents of the box should include
the following (See pic below):
• PRO 750 Wet Saw
• 180mm Diamond Blade
• Blade guard set comprising of bolt, wing nut,
guard support and blade guard
• Rip Guide
• Variable Angle Mitre Guide
• Wrench
• Owner’s Safety & Operating Manual
IMPORTANT
Your new Vitrex Versatile Power Pro
750 has a Super Quiet Induction Motor
for ultra smooth cuts. For best results
allow the blade to do the work, rather
than forcing the tile through the
machine. Should the blade stop, simply
ease the tile away and then continue
cutting using slightly less pressure.
Tel: +44 (0) 1253 789180 Tel: +44 (0) 1253 789180