Video Mount Products DVR-MB1 - Manual (Page 3)

Step 1
Before starting, lay out all parts to your mount and match them to the
parts list provided. Verify that you have all your parts before attempt-
ing to assemble the mount.
If you are rack mounting the DVR-MB1, proceed to the next step. If
you are surface mounting the DVR-MB1 then proceed to step 8.
Step 2
Remove the Top Lid
(#2) to provide better access to the inside of the
box.
Step 3
Apply the adhesive Velcro strip
(#5) to the bottom of the DVR and to
the bottom of the box where you want the DVR to sit. Place the DVR
into the box making sure the Velcro attaches properly. Wire the DVR
through the knockouts as needed.
Step 4
If you wish to adjust how the air is channeled through the DVR-MB1
you can shift the Vent Blockers
(#3) and/or Fan Assembly (#12) to
any of the four attachment points in the DVR-MB1. Note: The one
attachment point is on the left and right side towards the back of
the box and there are two attachment points on the front door of
the box. The Vent Blockers
and Fan Assembly can also be
completely removed if so desired without compromising the security
of the box.
Step 5
Reattach the Top Lid
to the Bottom Box .
Step 6
Attach the Ears
to the left and right sides of the Bottom Box
using the M4 screws .
Step 2: Removing the Top Lid
Step 3: Attaching the Velcro
Step 4: Adjusting the Vent
Blockers and Fan
Step 5: Reattaching the Top Lid
1
2
12
1
5
2
3
12 3
4
6
Step 6: Attaching the Ears to
the Bottom Box