Video Mount Products LCD-1CW - Manual (Page 3)

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount.
Step 2
Attach the mounting plate to the LCD using the M4 or M5
screws.
Step 3
Mark the ceiling or desired mounting surface in preparation of in-
stallation of ceiling plate . If mounting to wooden ceiling joists,
pre drill pilot holes using a 7/32” drill bit. Attach the ceiling plate
to the wooden ceiling joist using the 5/16” by 2.5” long lag screw
and washer . WARNING: Please verify that your mounting
surface will support the combined weight of your mount, mount-
ing hardware, and fl at panel. Also verify that the mounting sur-
face is safe to drill through. Please note only mounting hardware
for mounting to wooden ceiling joists will be provided with the unit.
If mounting to a surface other than wooden ceiling joists then other
hardware will be required. If in doubt or uncertain about any of the
above, please contact a professional installer.
Step 4
Attach the swivel bracket assembly from step 2 to the support tube
using the 3/8” screw , washers and nylon nut . Insert
adjustable screw into the back of the swivel bracket for
use when tilting the monitor.
Step 2: Attaching the mounting
plate to the LCD
Step 3: Attaching the ceiling
plate to the ceiling
Step 4: Attaching the swivel
bracket to the support tube
21
1
5 22
1
3 15
12
8 16
4
23 24