Video Mount Products FP-LFB - Manual (Page 3)

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount.
Step 2
Mark the wall or desired mounting surface in preparation of instal-
lation of wall mounting plate . If mounting to wooden studs, pre
drill pilot holes using a 7/32” drill bit. Attach the wall plate to
the wooden stud using the 5/16” by 2.5” long lag screw and
washer making sure the small ear fl aps are on the top rail of the
wall plate . WARNING: Please verify that your mounting surface
will support the combined weight of your mount, mounting hard-
ware, and fl at panel. Also verify that the mounting surface is safe
to drill through. Please note only mounting hardware for mount-
ing to wooden studs will be provided with the unit. If mounting to
a surface other than wooden studs then other hardware will be
required. If in doubt or uncertain about any of the above, please
contact a professional installer.
Step 3
Determine the correct screw size and if you need to use wash-
ers, lock washers, or spacers. Note: Spacers are used for TVs with
recessed hole patterns. Secure the TV to the mounting bracket
using the appropriate hardware through . Note: The
brackets have to be level with each other to work properly.
Step 4
Use the hooks in the mounting bracket to hook on the top rail
of the wall plate . Use security screws and the long allen key
to secure the TVs to the wall plate and to secure its horizontal
position.
Please verify that all nuts and screws are securely tightened.
Step 2: Mounting the wall plate
Step 3A: Attaching the mounting
brackets to the monitor
(spacers not needed)
WARNING: The installer of these products must verify that the mount
surface, ceiling or wall, will safely support the combined weight of
all attached equipment and hardware. Video Mount Products will
not be held liable for the improper use or installation of its products.
Enjoy Your Mount!
Step 4: Securing the mounting
brackets to the wall plate
1
1
1
1
3
2 5
4
1
2
21
Step 3B: Attaching the mounting
brackets to the monitor (spacers
used due to recessed hole patterns)
22
19