Alpine PXA-H800 - Manual (Page 65)

63
-EN
01GB08PXAH800.fm
ALPINE PXA-H800_EN 68-13530Z65-A (B5)
• Cabin temperature is too high (temperature inside the unit 85°C
or higher).
- Lower the cabin temperature to normal.
• Unit internal voltage is abnormal.
- Turn off the system immediately and contact an Alpine dealer.
• Connected device voltage is abnormal.
- Check for any abnormal connection with the externally
connected devices including amplifiers.
• Vehicle battery voltage is high.
- Check the battery voltage.
• Vehicle battery voltage is low.
- Check the battery voltage.
• Analog input audio signal level too high causing clipping.
- Lower the Analog input audio signal level.
• The level was raised too much with EQ settings and DSP output
was clipped.
- Lower the adjusted level of EQ, etc.
- Lower the volume.
• Cabin temperature is too high. (Internal temperature warning)
- Lower the cabin temperature to normal.
Specifications HI-TEMP (Over 85°C)
Audio Supply Voltage Low
Remote Out Voltage Low
Battery Voltage High
Battery Voltage Low
Graphic EQ number of bands
Front (left and right) 31 bands
Rear (left and right) 31 bands
Center 31 bands
Subwoofer 10 bands
Graphic EQ boost cut range ±12 dB (in 0.5 dB steps)
Parametric EQ number of bands
Front/Rear/Center 10 bands
Subwoofer 5 bands
Parametric EQ frequency
Front/Rear/Center 20/22/25/28/31.5/36/40/45/50/
56/63/71/80/90/100/110/125/
140/160/180/200/220/250/280/
315/360/400/450/500/560/630/
710/800/900/1k/1.1k/1.2k/1.4k/
1.6k/1.8k/2k/2.2k/2.5k/2.8k/3.2k/
3.6k/4k/4.5k/5k/5.6k/6.3k/7.1k/
8k/9k/10k/11k/12.5k/14k/16k/
18k/20k(Hz)
Initial setting:
Band 1 31.5 Hz
Band 2 63 Hz
Band 3 125 Hz
Band 4 250 Hz
Band 5 500 Hz
Band 6 1 kHz
Band 7 2 kHz
Band 8 4 kHz
Band 9 8 kHz
Band 10 16 kHz
Subwoofer 20/22/25/28/31.5/36/40/45/50/
56/63/71/80/90/100/110/125/
140/160/180/200(Hz)
Initial setting:
Band 1 25 Hz
Band 2 40 Hz
Band 3 63 Hz
Band 4 100 Hz
Band 5 160 Hz
Parametric EQ boost cut range ±12 dB (in 0.5 dB steps)
Time correction control range 0 to 20 ms (0.05 ms steps)
Frequency response 20 Hz to 20 kHz
S/N ratio >103 dB (IHF-A) (RCA INPUT)
>110 dB (IHF-A) (DIGITAL
INPUT)
Channel separation 90 dB
Input sensitivity 2 V (Analog) (RCA AUX
INPUT)
7 V (Analog) (SP AUX INPUT)
Subwoofer crossover 20 to 200 Hz (1/6 oct. steps)
Rated output 4V (with 10 k ohms load)
Distortion factor 0.01%
Input impedance 10 k ohms or higher
Output impedance 1 k ohm or less
Weight
PXA-H800 1.35 kg
RUX-C800 0.11 kg
01GB00PXAH800.book Page 63 Tuesday, February 8, 2011 9:04 PM