Tennsco Z-Line Low Profile Boltless Shelving - Manual (Page 3)

7. Attach the
remaining
shelf supports
at the desired
shelf levels.
8. If particleboard or
wire decking
was purchased,
place the decking
on each shelving
level. Particle-
board decking
should fit flush
inside the shelf
supports, while
wire decking
will sit slightly
below the shelf
support edges .
If you have
purchased a
single unit, your
shelving unit is
now complete.
For adder units,
see step 9.
6. With the help of an associate, connect the two
unit ends with left-to-
right shelf
supports (Ref
No. 3). Be
sure the shelf
support is
oriented as
shown below.
9. If joining more than
one unit together, your
original unit should have been
assembled with ZTP uprights on one end, as
described in step 5. Simply
continue adding shelf
supports and uprights
to complete your
additional units.
Shelf support