Tennsco Shelving with Plywood Beams - Manual (Page 3)

7. Shelf deck supports (Ref. No. 4) are necessary for
30" deep units only. Attach shelf deck supports by
inserting the metal prongs on the deck support into
the slots on the shelf supports. 69" x 30" units
require two shelf deck
supports per level (as
shown below);
42" x 30" units
require only
one shelf
deck support
per level,
placed in
the center.
8. If particleboard
decking (Ref.
No. 5) was ordered,
place the decking
on each shelving
level. The
decking should
fit flush inside
the shelf
supports.
If you have
purchased a
single unit,
your shelving
unit is now
complete.
For adder
units, see
step 9.
6. Attach the remaining shelf supports at the desired
shelf levels, making sure that all shelf supports
are completely
seated in the
upright slots.
NOTE: For
archive
storage
boxes to fit
stacked two-
high per
level, there
should be a
minimum of
16 holes
between
shelf
supports. We
recommend
placing the
bottom shelf
support rivet in the
2nd, 19th, 37, and 55th holes
on 84" high units, (shown above)
and in the 2nd, 20th, and 39th holes on 60" units.
9. If joining more than
one unit together, your
original unit should have been
assembled with ZTP uprights on one end, as
described in step 4. Simply
continue adding shelf
supports and uprights
to complete your
additional units.
Holes
55 & 56
Holes
37 & 38
Holes
19 & 20
Holes
2 & 3