Step by step installation instructions – Tennsco CK4824 User Manual
Page 3
1. Before beginning assembly, compare the
parts you have received against the parts list
on the front of this sheet to ensure that you
have all the necessary pieces.
3.
Attach two swivel casters (Ref. No. 2) and two
braking swivel casters (Ref. No. 3) to the caster
frame (Ref. No. 1), using the nuts and washers
provided (Ref. Nos. 6 and 7). Use a
9
/
16
"
wrench to tighten the casters securely.
NOTE: All casters must be tight for unit to
work properly.
Step By Step Installation Instructions
4. After making sure that the cabinet is un-
loaded, lay the cabinet on the floor with the
door facing up.
5. Position the caster kit frame on the bottom
of the cabinet. The back of the caster kit has
a "hem" that will fit over the flange at the
bottom rear of the cabinet
(see circled drawing
below).
8. Carefully set the unit upright on its casters. To
prevent the unit from rolling during this
process, we recommend two people perform
this step.
3
/
8
" Hex Nuts &
Lockwashers
Tools required: a
9
/
16
" wrench or nut driver and two
1
/
2
" wrenches or nutdrivers. Two people
recommended when setting storage cabinet upright after casters are attached. Assembly Time: ten to
fifteen minutes.
2. As you prepare to attach the casters, take
some time to consider where you want to
place the two swivel casters with brakes. If
the cabinet will be placed against the wall, we
recommend placing the braking casters
along the front of the base.
NOTE: It is
recommended that
the bottom of the cabinet is a minimum of
1
/
2
"
off the floor, in order to more easily attach
the caster kit to the unit.
Back Panel Flange
on Cabinet
Hem on
Caster Frame
Bolt through
these holes
6. Secure the cabinet to the caster kit frame by
attaching at the front with two
5
/
16
"-18 x
3
/
4
"
bolts and nuts (Ref. Nos. 4 and 5) through the
sill as shown. Use a
1
/
2
" wrench to tighten
securely.
Bolt
Nut
7. Before setting the storage cabinet upright, be
sure that all bolts and nuts are tight and that
the frame is secure.
THE CASTER KIT FRAME MUST BE
SECURELY MOUNTED TO THE CABINET
BASE BEFORE USE!
9. Your storage cabinet is now ready for mobile
use.
Hex Nut
5
/
16
"
-18 x
3/4
"
Bolt