Tennsco 1472 - Manual (Page 3)

14. Attach the right door
(Ref. No. 10) to the unit
in the same way you
attached the left door.
14. Place the locking handle
(Ref. No. 12) on the right
hand door and fasten with
two slotted bolts with
lockwashers.
Handle/Locking System Installation Instructions
17. Place the locking cam
retainer (Ref. No. 14)
over the square shank of
the door handle. Tap on
the edges of the cam
retainer with a hammer
until retainer sits firmly
against the locking cam.
B
B
10. Turn the unit on its side.
Then, attach the top (Ref.
No. 8) by sliding it under
the sides and header, with
the flange hanging over
the back. Secure with 14
bolts and nuts (three along
each side, four in the back,
and four along the front).
11. Set the unit upright and attach a
coat rod bracket (Ref. No. 18)
beneath the left side of the
cabinet shelf by inserting one
bolt through the hole in the left
edge of the shelf.
Secure with a nut.
Attach the right
bracket in the same
way. Then, slide the
coat rod (Ref. No. 17) through the
holes in the brackets (Inset E.)
Inset E Mount
brackets
by
attaching
here
with
one
bolt
and
nut.
Top fits
under
side flanges
Top tucks under
front flange
13. Attach the left door (Ref. No. 9)
to the unit by placing the door
on the hinges, aligning the
holes, and using a hammer
to tap the hinge pins (Ref.
No. 16) into place with the
side of a screwdriver.
9. Insert the partition (Ref.
No. 19) into the
cabinet, aligning
the four holes
in the partition
with the holes
in the cabinet
bottom and the
cabinet shelf. Attach
with four bolts and nuts, making
sure that the bolts are inserted from
the top downward (as shown at right) to prevent
stored items from being snagged.
14. Insert the four
partition shelves
(Ref. No. 20) at
the desired
levels. The
shelves should
be inserted
using the same
method used to
place the top
shelf (refer to
step 6).
15. Turn the handle to the open position, and
place the locking cam (Ref. No. 13)
over the square
shank of the door
handle. The latch
must be facing downward,
as shown at right.
16. With the handle still in the open position,
hook the locking bars (Ref. No. 11) to
the locking cam (see "A" at left). Then,
hold the lock bars in position while
sliding the nylon lock bar
guide inserts (Ref. No. 15)
over the lock bar ends
and through the
door slots (see
"B" at left).
A