Tennsco J2442A - Manual (Page 3)

2. Turn the handle to the
open position, and place
the locking cam (Ref. No. 12) over the
square shank of the door handle. The
latch must be facing
downward as shown.
10. Attach the right
door (Ref. No. 8) in
the same manner
as the left door,
placing the door on
the hinges and
connecting by
driving the remain-
ing two hinge pins
through the holes.
11. Lay the stiffener (Ref. No. 9)
across the top of the unit,
aligning the four holes
with the holes on
the left and right
edges of the unit.
Attach securely
with four bolts
and nuts.
1. Place the locking handle (Ref. No. 11) on the
right hand door and
fasten with two #8-32 x
1/4 slotted bolts and
lockwashers (Ref. No. 17).
Handle/Locking System Installation Instructions
4. Place the locking
cam retainer (Ref. No. 15)
over the square shank of
the door handle. Tap on
the edges of the cam
retainer with a hammer
until retainer sits firmly
against the locking cam.
3. With the handle
still in the open
position, hook the locking bars (Ref.
No. 13) to the locking cam (see "A" at
left). Then, hold the lock bars in
position while sliding the nylon lock
bar guide inserts (Ref. No. 14) over
the lock bar ends
and through the
door slots (see "B"
at left).
B
B
9. Attach the left door (Ref. No. 7) to the unit by
placing the door on the hinges, aligning the
holes, and dri-
ing two hinge
pins (Ref. No.
7) into place. If
the head of
your hammer is
too wide to hit the
pins without scraping the
cabinet, it may be help-
ful to place the flat edge of a
screwdriver on the pins and tap
the screwdriver with the hammer.
12. Attach the unit
top (Ref. No. 10) by
inserting the tabs on
the top into the slots
on the front of the
unit (see inset at left).
Pull the top over the
back of the unit and attach
with four bolts and nuts.
A
5. Attach the "dummy"
handle (Ref. No. 16) to
the left door using two
#8-32 x 1/4 slotted
bolts and lockwashers
(Ref. No. 17).
Insert the three tabs
into the slots on the
front of the unit.