Tennsco 1470 - Manual (Page 3)

2. Turn the handle to
the open position,
and place the
locking cam (Ref.
No. 13) over the
square shank of
the door handle.
The latch must be
facing downward
as shown.
8. Place bottom (Ref. No. 7) in the bottom lances of
the shelf
adjustment strips.
The
flange
with two
holes
should
face the
front,
and it
should hang
over the sill.
Bolt to the sill with two bolts and nuts.
9. Attach the top (Ref. No. 8) by sliding it
under the header and sides, with the
flange hanging over the back.
Secure with 14 bolts &
nuts (three
along
each
side,
four in
the back,
and four
along the front).
11. Attach the left door
(Ref. No. 9) to the unit by
placing the door on the hinges,
aligning the holes, and using a
hammer to tap the hinge pins
(Ref. No. 16) into place with
the side of a screwdriver.
10. Set the unit upright and insert
the remaining shelves at
your desired levels.
Insert shelf into
bottom lances.
Two holes must
be in front.
12. Attach the right door
(Ref. No. 10) to the unit
in the same way you
attached the left door.
1. Place the locking
handle (Ref. No. 12)
on the right hand
door and fasten with
two slotted bolts with
lockwashers.
Handle/Locking System Installation Instruc-
tions
4. Place the locking cam
retainer (Ref. No. 14)
over the square shank
of the door handle.
Tap on the edges of
the cam retainer with
a hammer until
retainer sits firmly
against the locking
cam.
3. With the handle still in the open
position, hook the locking bars (Ref.
No. 11) to the locking cam (see "A"
at left). Then, hold the lock bars in
position while sliding the nylon lock
bar guide inserts (Ref. No. 15) over
the lock bar ends and through
the door slots (see "B" at left).
A
B
B