Autostart CT-5060 - Manual (Page 4)

CT-5060 User Guide P. 4
Valet Mode
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, the Valet Mode will prevent the
engine from being remote-started accidentally.
To put the system into Valet Mode:
1. Turn the key to the
IGNITION ON (RUN)
position.
2. Within 3 sec. press the Valet button and release it. The LED will come
ON
. (The
system is in Valet Mode.)
To take the system out of Valet Mode:
1. Turn the key to the
IGNITION ON (RUN)
position.
2. Within 3 sec. press and release the Valet button. The LED will go
OUT
. (The system
is out of Valet Mode.)
The Valet button can only be used if the ignition key is in the
IGNITION ON (RUN)
position.
Ignition Valet
The system can be placed in Valet Mode to disable the remote starting capabilities. If the
vehicle needs to be serviced, or if you park it indoors, Valet Mode will prevent the engine
from being accidentally started by remote control.
To ENTER Valet Mode
1. With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash 3 times indicating the Module is now in Valet Mode. The
LED will turn
ON
solid.
To EXIT Valet Mode
1. With the key in the Ignition switch, turn the key to the
ON (RUN/IGNITION)
and then
OFF
positions 5 times within 10 seconds.
2. The Parking Light will flash twice indicating the Module is now out of Valet Mode.
The LED will turn
OFF
.
Remote Valet
This feature will put your vehicle into Valet Mode using the remote transmitter instead of
the Valet button as above.
Note: Once the Electronic Valet is activated, the remote starter and Alarm features are
disabled.
To put the system into Valet Mode:
1. Hold down the
UNLOCK
and
START/STOP
buttons simultaneously for 3 seconds.
2. The Parking Lights will flash 3 times.
The siren will chirp twice and the LED will come
ON
.
To take the system out of Valet Mode:
1. Hold down the
UNLOCK
and
START/STOP
buttons simultaneously for 3 seconds.
2. The Parking Lights will flash 2 times.
The siren will chirp twice, then pause, then chirp twice again, and the LED will go
OUT
.
Panic Mode
Safety feature: Activate Panic Mode in an emergency situation.