ShelterLogic 25757 10 x 20 Max AP Canopy - Manual (Page 5)

05-25757-0F Page 5
Insert Bungee Cord Through Grommet Secure Bungee Around Plastic Ball Grommet Panels for Bungees
13104
13101
Grommet
Panel
10066
13103 10072
13105
5. PlACe COver AND seCUre tO CANOPY FrAMe
A. Place cover over assembled roof frame with grommet panels facing down, aligned with cross rails.
B. Make sure the cover is properly aligned on the frame, secure the four corners of the cover with bungees
(10066) to the frame first . Attach remaining bungees.
Re-adjust bungees position along cross pole as needed to ensure a tight and even fit of the cover to the frame.
Grommet Panels for Bungees
13106
Grommet Panel
13103
10072
6. tIGHteN tHe COver WItH tWIst tIte ™
A. Wrap the cord with plastic ball and "S" hook at the corners of the cover
around the corner leg poles. Insert "S" hook into the hole of the corner leg
poles.
B. Twist each leg pole toward the inside of the shelter until the cover
becomes tight. Twist the leg poles equally to ensure the cover stays
aligned during tightening.
Twist-Tite ™ Tighten Cover
13105
10072
13101