Seed Hawk Hydraulic Drive 2011 Calibration Guide - Manual (Page 6)

Seed Hawk
®
Manual Calibration Guide
5
Pressing BEGIN from the
calibration screen brings up
this screen. The meter needs
to be primed before
calibration begins to ensure
full product flow during
calibration. Select prime
meter roller to prime the
meter. Empty the product out
of the calibration bucket this is
not needed for the rest of the calibration procedure. Select start
calibration to continue with the meter calibration. Selecting set
bin height brings up another screen to specify the bin height for
the bin level sensor.
Selecting start calibration
brings up this screen. Press
the START button. This will
cause the meter to turn, filling
the calibration bucket with
product. The INCREASE and
DECREASE buttons can be
used to control roller speed.
After an arbitrary amount of
revolutions Press the END
button (for lighter grains use
more revolutions). .
Press Left or Right buttons to
select the digit to modify, then
press Increase or Decrease to
change the value. Once the
weight of the metered product
is entered, move the arrow all
the way to the right then push
SUBMIT. Repeat the process
for the remaining meters.
NOTE: Do Not include the weight of the calibration bucket in the
metered weight value.