Seed Hawk LOUP III & VIPER PRO 2014 - Hydraulic Drive Calibration Guide User Manual

Page 31

Text mode
Original mode

SEED HAWK

2014 LOUP III & VIPER PRO™ HYDRAULIC DRIVE CALIBRATION GUIDE

Press the

INC button to increase the PWM Out-

put (this will increase the speed of the roller)

Use the

INC and DEC buttons to achieve the de-

sired roller rpm. It is important to calibrate as close
to the actual seeding rpm of the roller. Refer to the
Meter RPM charts (pg. 31-33) to get an approx-
imate rpm the roller will be turning during seeding.
based on the specific roller and drill width.

Once the meter is primed (at least two revolutions)
select

STOP. Empty the product caught and reposi-

tion the calibration bucket under the meter

Continue to next page