SANDPIPER MSA3-C - Manual (Page 8)

Model MSA3 Page 6 msa3dl7sm-REV0614
Recycling
Many components of SANDPIPER ® Metallic AODD pumps are made of recyclable materials.
We encourage pump users to recycle worn out parts and pumps whenever possible, after any
hazardous pumped fluids are thoroughly flushed.
Pump complies with EN809 Pumping Directive and
Directive 98/37/EC Safety of Machinery, and ATEX
100a Directive 94/9/EC Equipment for use in Potentially
Explosive Environments. For documentation consult the
manufacturer or visit: www.warrenrupp.com
IMPORTANT
Read these safety warnings
and instructions in this
manual completely, before
installation and start-up
of the pump. It is the
responsibility of the purchaser to retain this
manual for reference. Failure to comply with
the recommendations stated in this manual will
damage the pump, and void factory warranty.
WARNING
In the event of diaphragm
rupture, pumped material
may enter the air end of the
pump, and be discharged
into the atmosphere. If
pumping a product which is hazardous or toxic,
the air exhaust must be piped to an appropriate
area for safe disposition.
Before pump operation,
i n s p e c t a l l g a s k e t e d
fasteners for looseness
caused by gasket creep. Re-
torque loose fasteners to
prevent leakage. Follow recommended torques
stated in this manual.
CAUTION
POSSIBLE EXPLOSION
HAZARD can result if 1, 1,
,-Trichloroethane,Methylene
C h l o r i d e o r o t h e r
H a l o g e n a t e d H y -
d r o c a r b o n s o l v e n t s a r e u s e d i n
pressurized fluid systems having Aluminum
or Galvanized wetted parts. Death, serious
bodily injury and/or property damage could result.
Consult with the factory if you have questions
concerning Halogenated Hydrocarbon solvents.
WARNING
Before doing any main-
tenance on the pump,
be certain all pressure is
completely vented from the
pump, suction, discharge,
piping, and all other openings and connections.
Be certain the air supply is locked out or made
non-operational, so that it cannot be started while
work is being done on the pump. Be certain that
approved eye protection and protective clothing
are worn all times in the vicinity of the pump.
Failure to follow these recommendations may
result in serious injury or death.
WARNING
Before maintenance or
repair, shut off the com-
pressed air line, bleed the
pressure, and disconnect
the air line from the pump.
The discharge line may be
pressurized and must be bled of its pressure.
WARNING
Take action to prevent static
sparking. Fire or explosion
can result, especially when
handling flammable liquids.
The pump, piping, valves,
containers or other miscellaneous equipment
must be grounded. (See page 6).
WARNING
When used for toxic or
aggressive fluids, the pump
should always be flushed
clean prior to disassembly.
WARNING
WARNING
Airborne particles and loud
noise hazards.
Wear ear and eye protection.
II 2GD T5
CAUTION
Pump not designed,
tested or certified to be
powered by compressed
natural gas. Powering
the pump with natural
gas will void the warranty.
WARNING
Use safe practices
when lifting
kg