SANDPIPER SSB2-A - Manual (Page 8)

Model SSB2-A Type 3 Page 6 ssb2dl3sm-REV0614
This pump is pressurized
internally with air pressure
during operation. Always
make certain that all bolting
is in good condition and
that all of the correct
bolting is reinstalled during assembly.
WARNING
Before pump operation,
i n s p e c t a l l g a s k e t e d
fasteners for looseness
caused by gasket creep. Re-
torque loose fasteners to
prevent leakage. Follow recommended torques
stated in this manual.
CAUTION
When used for toxic or
aggressive fluids, the pump
should always be flushed
clean prior to disassembly.
WARNING
B e f o r e m a i n t e n a n c e
or repair, shut off the
c o m p r e s s e d a i r l i n e ,
bleed the pressure, and
disconnect the air line from
the pump. The discharge line may be pressurized
and must be bled of its pressure.
WARNING
B e f o r e d o i n g a n y
maintenance on the pump,
be certain all pressure is
completely vented from the
pump, suction, discharge,
piping, and all other openings and connections.
Be certain the air supply is locked out or made
non-operational, so that it cannot be started
while work is being done on the pump. Be certain
that approved eye protection and protective
clothing are worn all times in the vicinity of the
pump. Failure to follow these recommendations
may result in serious injury or death.
WARNING
WARNING
Airborne particles and
loud noise hazards.
Wear ear and eye
protection.
WARNING
In the event of diaphragm
rupture, pumped material
may enter the air end of the
pump, and be discharged
into the atmosphere. If
pumping a product which is hazardous or toxic,
the air exhaust must be piped to an appropriate
area for safe disposition.
IMPORTANT SAFETY
INFORMATION
Take action to prevent static
sparking. Fire or explosion
can result, especially when
handling flammable liquids.
The pump, piping, valves,
containers or other miscellaneous equipment
must be grounded. (See page 8)
WARNING
IMPORTANT
Read these safety warnings
and instructions in this
manual completely, before
installation and start-up
of the pump. It is the responsibility of the
purchaser to retain this manual for reference.
Failure to comply with the recommendations
stated in this manual will damage the pump,
and void factory warranty.
Read these safety warnings
and instructions in this
manual completely, before
installation and start-up
of the pump. It is the responsibility of the
purchaser to retain this manual for reference.
Failure to comply with the recommendations
stated in this manual will damage the pump,
and void factory warranty.
RECYCLING
M a n y c o m p o n e n t s o f S A N D -
P I P E R ® A O D D p u m p s a r e m a d e
of recyclable materials (see chart on page 9 for material
specifications). We encourage pump users to recycle
worn out parts and pumps whenever possible, after
any hazardous pumped fluids are thoroughly flushed.
II 2GD T5
CE
Pump complies with Directive 94/9/EC, EN13463-1
Equipment for use in Potentially Explosive
Environments. For reference to the directive
certificates visit: www.warrenrupp.com.
The Technical File No. AX1 is stored at
KEMA, Notified Body 0344, under Document
#203040000.
Pump complies with EN809 Pumping Directive,
Directive 2006/42/EC Machinery, according to
Annex VIII.
CAUTION
Pump not designed,
tested or certified to be
powered by compressed
natural gas. Powering
the pump with natural
gas will void the warranty.
WARNING
Use safe practices
when lifting
kg