Assembly – RotoZip CR18L User Manual

Page 8

CHANGING THE COLLET

The bit flutes are sharp and

should be handled with

caution.
The 1/8" collet is used with 1/8" diameter

bits, the 1/4" collet is used with 1/4" diameter

bits and the 5/32" collet is used with 5/32"

diameter bits.
To change collets, loosen the collet nut with

the included wrench and remove the bit.

Continue to loosen and unscrew the collet

nut until you can remove it from the tool.

Remove the collet and replace it with the

other (Fig. 3).

(Each collet is double-ended, and either end

is acceptable to use.) By hand, re-tighten

the collet nut around the collet in a clockwise

direction. You are now ready to insert a new

bit as instructed in Installing Bits (Fig. 4).

Disconnect battery pack
from tool or place the switch

in the locked or off position before making
any assembly, adjustments or changing
accessories

. Such preventive safety measures

reduce the risk of starting the tool accidentally.

Make certain that the collet nut is securely

tightened before turning the tool on.

REMOVING, INSTALLING, AND

ADJUSTING THE DEPTH GUIDE

In order to remove the depth guide from the

tool, turn the thumb screw counter-clockwise

until you can remove it from the tool. The

depth guide should then pull freely from the tool.
To reattach the depth guide, line up the slot in

the depth guide with the threaded hole in the

metal housing and re-install the thumb screw

by rotating it clockwise until tight. Be careful

not to cross-thread the thumb screw.
The depth guide allows you to control the

depth of cut. Loosen the thumb screw by

turning it counter-clockwise until the depth

guide can slide freely on the metal housing.

For bits with a guide point (Drywall XBITS™,

Guidepoint

and Window & Door Zip

bits)

make sure that the entire guide point tip will

extend 1/8” beyond the material thickness

(Fig. 2). For standard point drywall Zip

bits,

make sure that the fluted end of the bit

extends 1/8” beyond the material thickness.

Assembly

WARNING

INSTALLING BITS

The bits are held by a collet system. Use either

the 1/8", 1/4" or 5/32" collet depending on the

size of the bit shank.
Depress and hold the shaft-lock in and rotate

the collet nut and shaft until the shaft-lock

engages and holds the shaft. Use the

included wrench to loosen the nut by rotating

it counter-clockwise (Fig 4).
Insert the bit into the collet so approximately

1/8" of the shank exposed. Re-engage the

shaft lock and tighten the nut by rotating it

clockwise by hand, then with the wrench until

the bit is held securely.

SHAFT

LOCK

COLLET

NUT

1/8"

THUMB SCREW

FIG. 2

OUTPUT SHAFT

1/8"

COLLET NUT

SHAFT

LOCK

FIG. 3

FIG. 4

-8-

RZ 2610955692 11-08:RZ 2610955692 11-08 11/10/08 9:24 AM Page 8