Adjustment – RIKON Power Tools 70-200EVS User Manual

Page 7

Text mode
Original mode

3.4 INSTALLING TOOL HOLDER ON THE

LATHE BED

- Located the tool holder from the carton, and install it onto the
lathe bed with two pan head screws. (See FIG.4)

FIG. 4

FIG. 5

3.5 SECURE LATHE TO A SOLID WORK

SURFACE

- The lathe must be attached to a solid work surface or stand.
Four mounting holes are easily accessible at the base of the
lathe. (See FIG.5)

FIG. 6

FIG. 7

Tool holder

Mounting holes

FIG. 5

4. Adjustment

4.1 KNOCKOUT BAR

- The knockout bar is used to remove the spur center from the
headstock spindle. Insert knockout bar into hole at opposite side
from spur center. (See FIG.6)

- The knockout bar is also used to remove the live center from
the tailstock spindle. Loosen locking and rotate the hand wheel
counter clockwise to retract spindle into the body of the tailstock.
The live center will be pushed out of the spindle. (See FIG.7)

Knockout bar