RIKON Power Tools 10-050 - Manual (Page 15)

15
Raising and Tilting the Saw Blade
1. To raise or lower the saw blade, loosen the lock
knob (A, Fig. 24) and turn the handwheel (B, Fig.
24) on the saw front until desired height is reached.
Tighten lock knob. The blade should be adjusted
1/8” to 1/4” above the top surface of the material
being cut.
2. To tilt the saw blade, loosen the lock knob
(C, Fig. 24) found on the left side of the table saw
and turn handwheel (D, Fig. 24) until desired angle
is obtained, then tighten lock knob.
Switch Operation
NOTE: The switch has a built in safety feature and
will not restart if the breaker is tripped.
1.) To start the saw, depress the green button at
the top of the switch (A, Fig. 25).
2.) To shut the saw off, hit the large stop paddle
with your hand. For hands free operation, you can
bump the large stop paddle with your knee (B, Fig.
25).
Figure 24
Figure 25
Operation
A
B
A B
C
D