RIKON Power Tools 30-140 - Manual (Page 10)

A
C
B
Figure 16
REMOVING THE CHUCK
1. Open the chuck jaws as wide as possible to
prevent damage.
2. Lower the spindle until the slot in the spindle is
exposed. (Fig.14)
3. Position the table approximately 1/2” below the
extended chuck.
4. Turn the chuck until a through hole is exposed
in the spindle.
5. Insert the Key-drift provided into the slot.
(Fig.15)
6. Gently tap the key-drift with a mallet to release
the chuck.
B
A
Figure 15
Figure 14
10
1. Tighten the locking lever (A-fig.16) onto the
table support bracket (B-Fig.16) and install the
table raising/lowering handle (C-Fig.16).