RIKON Power Tools 30-120 User Manual

Page 12

SETTING THE SPINDLE LOCK

1. Loosen the depth stop collar lock (A-Fig. 25)

as shown.

2. Lower the spindle to the desired depth. (Fig.

26)

3. Turn the depth stop collar clockwise until the

collar stops (B-Fig. 25).

4. Tighten the depth stop collar lock.

Figure 25

Figure 23

Figure 26

CHANGING SPINDLE SPEEDS CONT.

Figure 24

NOTE:

SETTING THE DRILL DEPTH

1. With the spindle in the up position, loosen the

depth stop collar lock (A-Fig. 25) as shown.

2. Turn the depth stop collar clockwise until the

pointer reads the desired drill depth on the

scale (B-Fig. 25).

4. Tighten the depth stop collar lock.

6. Place the belt on the pulleys in relation to the

speed chosen on the speed selection chart

starting with the motor pulley first. (Fig. 23)

7. Push the belt tension handle backward on the

motor until there is approximately 1/2"

deflection in the belt. (Fig. 24)

8. Tighten the belt tension lock handle.

9. Close the belt guard.

10. Reconnect the Drill Press to the power.

Figure 26 shows the spindle in the locked po-

sition.