RIKON Power Tools 10-325 - Manual (Page 8)

k
1. Check contents against parts list. Leave all bolts finger tight until saw is placed on stand.
2. Install the star knob (11S) to the right end panel with the 6MM hex socket screw (12S) and nylon
nut M6-1.0 (8S) as shown.
3. Install the left panel (1S), back panel (3S) and right panel (4S) onto the base panel (6S), using
the M8x12 hex bolts (14S), 8MM spring washer(18S) and 8MM washers (13S). Make sure that the
hinges in the left panel and the oval holes on both left and right panels are pointing upward.
4. Fasten the side panels to the back panel, using the M8x12 hex bolts (14S), 8MM spring
washer (18S) and 8MM washers (13S).
5. Add three M8x12 hex bolts and washers to the front edge of each side panel, leave loose. Fasten
the front bracing members (2S) on to the front of the left and right side panels. Next, install the
shelf on the side panels.
6. Install the door (7S) on to the left end panel, and add the hex socket screw, bushing and nylon nut.
7. With assistance lift bandsaw and carefully position in place on top of stand.
8. Mount bandsaw on the stand using four M6x40mm screws (17S), M6 washers (16S), and 6mm hex
nuts (15S). Tighten stand bolts.
8
Caution: To avoid back injury, get help lifting the bandsaw. Bend your knees, lift with your legs, not
your back.
Stand Assembly
Item# Description Qty Item# Description Qty
10-325-1S End panel (L.H.S.) 1 10-325-10S Hex socket screw 1
10-325-2S Front brace 2 10-325-11S Star knob 1
10-325-3S Back panel 1 10-325-12S Hex socket screw 1
10-325-4S End panel (R.H.S.) 1 10-325-13S Washer M8 18
10-325-5S Shelf panel 1 10-325-14S Hex bolt M8x12 16
10-325-6S Base panel 1 10-325-15S Hex nut M6 8
10-325-7S Door 1 10-325-16S Washer 6mm 12
10-325-8S Nylon nut M6-1.0 2 10-325-17S Hex bolt M6x40mm 4
10-325-9S Bushing 1 10-325-18S Spring washer 8mm 16