beautypg.com

Operation, How to use control dials, Lux (light level) – Nature Power Solar Motion Light 500 Single (22260) User Manual

Page 5: Time, Sens (sensitivity), Location of solar light, Troubleshooting

background image

Page 5

Page of 6

5

OPERATION    

1.

Before  the  Solar  Motion  Light  can  operate  to  its  full  capacity,  the  Solar  Panel  needs  to  be  in  sunlight  for  3  days  

to  fully  charge  the  included  battery.  Charging  should  be  done  with  the  unit  in  the  “OFF”  position.  

2.

Located  at  the  bottom  of  the  Battery  Housing  (5)  there  is  a  switch  with  three  positions:  

Turn   the   switch   to   “AUTO”   position,   the   light   will   turn   on   automatically   at   night   when   motion   is  

detected  by  the  Motion  Detector  Head  (6).  

Turn  the  switch  to  “ON”  position,  the  light  can  be  used  as  a  standard  light  for  constant  illumination.  

Turn  the  switch  to  “OFF”  position,  the  light  will  remain  off  and  will  not  detect  any  movement.    

HOW  TO  USE  CONTROL  DIALS  

The  Solar  Motion  Light  has  3  different  control  dials  which  control  the  light’s  duration,  
sensitivity  to  light  and  sensitivity  to  motion.  

LUX  (LIGHT  LEVEL)  

1.

The   LUX   Adjusting   dial   (9)   tells   the   sensor   the   level   of   darkness   that   must   be  

reached  before  the  light  turns  on.  

2.

If  set  to  the  maximum  

  level,  the  light  will  go  on  in  daylight.  

3.

If  set  to  the  minimum  setting  

  the  sensor  will  only  trigger  the  light  to  turn  on  at  dusk  or  when  it  is  dark  

out.  This  is  the  ideal  position  for  general  usage.  

TIME  

1.

The  TIME  Adjusting  dial  (11)  sets  the  duration  of  illumination  time.  

2.

The   TIME   is   adjustable   from   8   seconds   to   2   minutes.   Rotating   the   dial   clockwise   will   increase   the

 

illumination  time.  

SENS  (SENSITIVITY)  

This  determines  the  range  of  motion  detection:  
1.

Minimum  position  –  Low  Range.  

2.

Mid  Position  -­‐  Normal  setting.  

3.

Maximum  position  -­‐  Maximum  range.  

 

LOCATION  OF  SOLAR  LIGHT  

For   best   results,   please   locate   the   Solar   Panel   from   your  
COB   Solar   Light   in   a   position   where   it   can   absorb   direct  
sunlight  on  the  solar  panel,  and  generally  free  from  cover  
and  shade.      

 

TROUBLESHOOTING  

If  the  Solar  Motion  Light  does  not  illuminate  when  movement  in  front  of  the  sensor  is  obvious,  please  observe  
the  following:    

Ensure  the  solar  panel  is  in  a  location  where  it  will  receive  maximum  sunlight  during  daytime  hours.