Nature Power Solar Post Lamp (21010) - Manual

Solar Post Lamp
21010
Instruction Manual
Features
 Solar powered by high quality crystalline solar panel
 Supper Bright LED’s
 Water proof design provides longer life in all weather
conditions
 Automatically turns the light on at dusk
 OFF/P/ON switch, strong/weak brightness
optional mode
 6 Ft. High
 Aluminum construction
Location of the Solar Panel
For best result, position the solar panel where it can
get direct sunlight, and is free from cover and shade.
(As shown in figure 1). The Solar Post Lamp should
be left to charge for 2 sunny days before initial use
Mount Instructions
Post Lamp Base Instructions (see Figure 2 and Figure 3))
1. Carefully remove all the fittings from the box. (Figure 3)
2. Choose a location to place your Solar Post Lamp. Make sure the location is flat
otherwise the lamp will not be straight.
3. Mark the place with the holes on the Lamp Base (5, Figure 3).Then Drill holes in the
location over the marked place.
4. Place the Anchor (Figure 2) in the holes, add the nut and twist until tightened
5. Release the Nut from the Anchor and put the Lamp Ground Base (5) or the Lamp Wall
Bracket onto the Anchor, the Anchor should be through the holes.
6. Now add the Pad and Spring Pad onto the Anchor (see figure 2), then tighten with the
Nut. Make sure Lamp Ground Base (5) or the Lamp Wall Bracket is secure and stable.
Lamp Ground mounting (see figure 3)
1. Install the Lamp Pole (4) onto the Lamp Ground Base (5) with the 3 screws supplied
and L shape wrench.
2. Install Lamp pole (3 & 2) by twisting clockwise.
3. Make sure all the lamp poles are secure and tight, and then twist the Lamp Head (1)
onto Lamp Pole (2) by twisting clockwise.
Lamp Wall mounting (optional) (see figure 4)
1) After installing the Wall Bracket, fixing the Nut onto the
Wall Bracket with the supplied Screws.
2) Twisting the Lamp Head onto the nut and twist
clockwise.