FallTech Sling Anchors - Manual (Page 12)

23
carabiner or snap hook which is attached to the Web Pass-Thru
Sling Anchor does not make direct contact with the edge of the
structural member or any other obstruction. Such contact could
force a roll-out or accidental disengagement.
Once the above steps have been taken, the user will have access to
their work area while walking and moving at normal speeds. It is
important not to make sudden or dramatic movements! When using this
device, care must be taken to be aware of the work environment and any
hazards, obstructions or obstacles that may exist. Be careful of any and
all fall hazards and also be aware of slipping and tripping hazards as
well.
Fig. 3.3
Installation Method for Web Pass-Thru Sling Anchor
Fig. 3.4
Correct Installation of Web Pass-Thru Sling Anchor
24
3.8: Installation and Use – Cable Pass-Thru Sling Anchors
1. Select the appropriate FallTech Cable Pass-Thru Sling Anchor
based on the work conditions and specific hazards (See Section
3.2 for recommendations).
2. Read, understand and comply with manufacturer’s instructions
for each component of your Personal Fall Arrest System (Full-
Body Harness, Connecting Devices, Anchorage Connectors,
etc.). Be sure to choose components that are compatible with
this Cable Pass-Thru Sling Anchor. If you have questions about
product or component compatibility, be sure to contact FallTech
for additional instructions.
3. Calculate possible swing fall hazards, total fall distance, and
required clearance distance. If you have a swing-fall hazard or
do not have the required clearance distance, STOP and
reevaluate your application and system. Your work location
should never exceed an angle of 15 degrees in any direction in
relation to your anchorage location.
4. Inspect this Cable Pass-Thru Sling Anchor, and all components
of your Personal Fall Arrest System in accordance with Section 8
of this manual. Be sure to consult, and adhere to the
instructional materials, labels and warnings accompanying
the other components of your PFAS as well.
5. Ensure that the rated structural member to which you are about
to attach your Cable Pass-Thru Sling Anchor is free of sharp,
jagged or abrasive edges. If it is not, cover these hazards with a
tarp, pad or moving blanket to protect your Cable Pass-Thru
Sling Anchor. (See Section 5 of this manual for details on proper
anchorage strength)
6. Place your Cable Pass-Thru Sling Anchor over the top of the
structural member so that the large O-ring is hanging on one
side and the small O-ring is hanging on the other. Pass the
small O-ring through the large O-ring, and cinch the Cable Pass-
Thru Sling Anchor down tight. (See Figure 3.5)
7. Check your installation to ensure that the Cable Pass-Thru Sling
Anchor cannot come off of the structural member at any point
along the intended path of movement or at joints or ends.
8. Ensure your Full Body Harness is properly donned and adjusted
and that your connecting device is securely attached to your
back D-ring. Tie-off to the small O-ring on your Cable Pass-Thru
Sling Anchor with your connecting device.
9. Proceed cautiously with your work. Do not run, jump or over-
reach. Any type of sudden movement may cause you to
lose your footing. Move with care and deliberation at all
times while tied-off and working at heights.