FallTech Sling Anchors - Manual (Page 11)

21
Fig. 3.1
Installation Method for Choker Sling Anchors
Fig. 3.2
Correct Installation of Choker Sling Anchors
Scaffold Choker Choker Sling Anchor
3.7: Installation and Use – Web Pass-Thru Sling Anchors
1. Select the appropriate FallTech Web Pass-Thru Sling Anchor
based on the work conditions and specific hazards (See Section
3.2 for recommendations).
2. Read, understand and comply with manufacturer’s instructions
for each component of your Personal Fall Arrest System (Full-
Body Harness, Connecting Devices, Anchorage Connectors,
etc.). Be sure to choose components that are compatible with
this Web Pass-Thru Sling Anchor. If you have questions about
22
product or component compatibility, be sure to contact FallTech
for additional instructions.
3. Calculate possible swing fall hazards, total fall distance, and
required clearance distance. If you have a swing-fall hazard or
do not have the required clearance distance, STOP and
reevaluate your application and system. Your work location
should never exceed an angle of 15 degrees in any direction in
relation to your anchorage location.
4. Inspect this Web Pass-Thru Sling Anchor, and all components of
your Personal Fall Arrest System in accordance with Section 8 of
this manual. Be sure to consult, and adhere to the
instructional materials, labels and warnings accompanying
the other components of your PFAS as well.
5. Ensure that the rated structural member to which you are about
to attach your Web Pass-Thru Sling Anchor is free of sharp,
jagged or abrasive edges. If it is not, cover these hazards with a
tarp, pad or moving blanket to protect your Web Pass-Thru Sling
Anchor. (See Section 5 of this manual for details on proper
anchorage strength)
6. Place your Web Pass-Thru Sling Anchor over the top of the
structural member so that the large D-ring is hanging on one side
and the small D-ring is hanging on the other. Pass the small D-
ring through the large D-ring, and cinch the Web Pass-Thru Sling
Anchor down tight. (See Figures 3.3 and 3.4)
7. Check your installation to ensure that the Web Pass-Thru Sling
Anchor cannot come off of the structural member at any point
along the intended path of movement or at joints or ends.
8. Ensure your Full Body Harness is properly donned and adjusted
and that your connecting device is securely attached to your
back D-ring. Tie-off to the small D-ring on your Web Pass-Thru
Sling Anchor with your connecting device.
9. Proceed cautiously with your work. Do not run, jump or over-
reach. Any type of sudden movement may cause you to
lose your footing. Move with care and deliberation at all
times while tied-off and working at heights.
10. Do not allow your connecting device to pass under your arm or
between your legs – severe injury or death may result. Also
avoid sharp edges which may damage your connecting device in
the event of a fall.
11. If the structural member that this Web Pass-Thru Sling Anchor is
attached to is sloped or vertical, the Web Pass-Thru Sling
Anchor must be positioned next to a stop which will prevent it
from sliding or moving in the event of a fall.
12. If you are tied-off at the foot-level, or in a manner that will allow
more than six feet of free fall, ensure that your connecting device
is rated for extended free falls. Also ensure that the gate of your