beautypg.com

The installation of the pc case, Installing the pc case – Elitegroup EZ-Buddie2 D21 I4-3 Install v.3 User Manual

Page 12

background image

12

D. We strongly suggest that remove the

ODD Bezel from the Optical Device

Disk

E. Screw the drive to the left and right

sides with two screws each.

.

D. Plug the one end of the gray

flat-cable into the white IDE by the

direction of the foolproof design.

E. Plug the other end of the gray

flat-cable into the driver by the

direction of the foolproof design.

F. Plug the power cord with the red

line on the inside.

The Installation of the PC case

Installing the PC case

A. Lay the cover on the chassis leaving a 5cm clearance

from the front panel, and then push it forward to lock the

cover.

B. Screw the cover with three screws and finish with the

hardware installation.

This clearance is about
5cm. A longer or shorter
clearance may causes
inconvenience in
installation.