Elitegroup EZ-Buddie2 D21 I4-3 Install v.1 - Manual (Page 4)

4
appearance of a red ”OVER CLOCK” icon on the upper right of the shown frequency
value. After this, the tuner will be again set for adjusting volume.
5. Reboot the system with the frequency locked will allow the system operates in that
frequency after booting up, otherwise in default frequency.
6. If you want to adjust the frequency, just push the tuner again.
FM Radio Tuning FM channel manual setting: each notch clockwise will increase 1KHz, and
counterclockwise will decrease 1KHz.
FM channel auto search: this function can be started by pushing the tuner, and will
pause at a channel where a radio station is detected. Turning
the tuner can interrupt this function and resume to manual
mode.
5
Alarm Setting 1. In the Clock mode you can use this tuner to set the alarm by:
First, push once to enter the ”hour” setting mode. The hour digit shall be blinking.
Turn the tuner to adjust the number and push the tuner once to confirm it. Then, shall
be in the ”minute” setting mode, in which the minute digit is blinking. Turn the tuner to
adjust the number and push the tuner once to confirm it. Then, shall be back to the
normal Clock mode with a green ”Alarm” icon indicating the alarm is activated.
2. At the alarm time the system will automatically switch to the FM Radio mode and start
to play the radio station that was set last time before switching to the Clock mode.
FM Radio Volume FM volume adjusting (adjusting the FM Radio signal level): turn the tuner clockwise to
increase the volume, and counterclockwise to decrease.
6
Clock/ Radio Switch Push it to switch to or from the Clock mode.
Note:
a. The FM channel factory default is set using the jumpers on the back of the PCB of the Front Display Board FM
Module side.
b. There are four kinds of the jumper setting for matching with your zone (shipping area):
Jumper Setting Country Frequency Range Default Step