Elitegroup P50CA v.4 - Manual (Page 4)

■ chapter 4 upgrading your computer
4-4
6. Push the HDD module to the right and separate it from
the connector. Lift the module away from the bay.
7. Locate and remove 4 Screw C’s from the HDD module.
Remove the metal case.
8. Re-attach the metal cover to the new hard drive and
tighten 4 Screw C’s. Note the green PC board of the hard disk
drive is facing against the metal case.
9. Re-attach the HDD module to the HDD connector. And
re-attach 1 Screw B’s.
10. Put the HDD cover back and re-attach 2 Screw A’s.
Congratulations! You have now completed the hard drive