Elitegroup G322 - Manual (Page 33)

25
• Carefully pick up the CD disk by the edges and – while pressing
down on the center ring – remove the CD/DVD-ROM/Combo from
the tray.
• Do not insert any foreign objects into the disc tray. If you
experience difficulty when ejecting the CD disk tray, stretch a
paper clip (or use a pin or a thin metal rod) and insert it into the
emergency eject hole located on the right side of the front panel.
The CD disk tray should eject immediately. This procedure can
also be used to remove a CD from the drive when the Notebook is
powered off.
Power Saving Modes
This section contains information on the Notebook’s power system,
including the AC Adapter, the battery system, recharging the battery, and
tips for conserving battery power. The power system is comprised of two
parts, the AC Adapter and the battery system. The AC Adapter converts
AC power from a wall outlet to the DC power required by the computer.
The Battery Power System
A fully charged pack will provide battery life depending on your system
configuration application it runs. Before using the computer on battery
power for the first time, check the battery status icon on the Windows
Toolbar to make sure the battery is fully charged.
See Battery Status later in this section for a description and explanation of
the Windows Battery icon. If possible, always charge the battery
completely.
If you use the battery so frequently that it
exceed more than 20 times by fully discharging/charging in a
single month alone, we recommend you to perform the “Battery
Calibration” process every 3 months to maintain the battery life.
Please refer to the topic on “Battery Calibration” describing how
to calibrate your system battery discussed on the latter part of
this chapter.
If you discover the battery life is getting shorter, please perform
the “Battery Calibration” process immediately.
Removing the Battery Pack
To remove the battery pack from its compartment, please refer to Chapter
3, Inserting and Removing the Battery Pack.