Elitegroup 755SI4 v.2 - Manual (Page 13)

■ chapter 2 trouble shooting
2-13
Network Adapter / Ethernet Problems
The Ethernet adapter does not work -
Go to [Start > Settings > Control Panel > System >
Hardware > Device Manager]. Double-click on Network
Adapters and check if SiS PCI 10/100M Fast Ethernet Adapter
appears as one of the adapters. If it does not exist, Windows
has not detected the National Semiconductor Fast Ethernet
adapter or the device driver has not been installed properly. If
there is a yellow mark or red-cross on the network adapter, it
may be a device or resource conflict. Replace or update the
device driver from the factory CD-ROM disk or consult
Windows manual on how to solve the resource conflict
problem.
Make sure the physical connections on both ends of the
cable are good.
The hub or concentrator may not be working properly.
Check to see if other workstations connected to the same hub
or concentrator is working.
The Ethernet adapter does not appear to operate in the
100Mbps transmission mode -
Make sure the hub you are using supports 100Mbps
operation.
Make sure that your RJ-45 cable meets the 100Base-TX
requirements.
Make sure the Ethernet cable is connected to the hub
socket that supports 100Base-TX mode. The hub may have
both 100Base-TX and 100Base-T sockets.