Burcam F80350 ELECTRONIC GARAGE FANAIR - Manual (Page 2)

SAFETY INSTRUCTIONS :
This fine product that you have just purchased is constructed from the highest
quality materials and workmanship.
Before installation and operation, we recommend the following procedures :
CHECK WITH YOUR LOCAL ELECTRICAL AUTHORITY TO ENSURE YOU
COMPLY WITH LOCAL ELECTRICAL REGULATIONS. THESE ELECTRICAL
CODES HAVE BEEN DESIGNED FOR YOUR SAFETY. BE SURE TO
COMPLY WITH THESE CODES.
WE RECOMMEND THAT A SEPARATE AND DEDICATED CIRCUIT BE
PROVIDED FROM YOUR HOME ELECTRICAL DISTRIBUTION PANEL.
IT SHOULD BE PROPERLY PROTECTED WITH EITHER A FUSE OR A
CIRCUIT BREAKER. A GROUND FAULT CIRCUIT INTERRUPTER (GFCI)
IS MANDATORY. CONSULT A LICENSED ELECTRICIAN FOR ALL WIRING.
THE GROUND TERMINAL ON THE THREE PRONG PLUG SHOULD
NEVER BE REMOVED. THEY ARE SUPPLIED AND DESIGNED FOR
YOUR PROTECTION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR
PRODUCT WITH THE POWER CONNECTED. BE SURE TO UNSCREW
THE FUSE OR TRIP THE BREAKER TO THE OFF POSITION AND
REMOVE THE POWER PLUG FROM THE RECEPTACLE. BEFORE
PROCEEDING
The necessary tools for the installation are :
- One electric reciprocal saw or one 4 1/4" diameter (110mm) hole saw
or jigsaw;
- One electric drill with a 1/4" (6mm) pilot drill bit, 12 inches (30cm) in length or
more.
- Measuring tape;
- Screwdrivers;
- Hammer;
- White weather seal caulking for arond the outside vent.
INSTALLATION GUIDE FOR THE BURCAM
Garage Fan Air
MODEL F80350
A
B
C
D
Preparation
2