Burcam 150143 HEAT SHRINK SPLICING KIT 4 TUBES - Manual

To avoid risk of electric shock, remove the power
cord from the electrical outlet.
Step 1 : Strip approx. 1/4” (6mm) of wire insulation
from both end of wires to connect. Clean wires
about 3” from ends and put tube over one end.
Step 2 : Insert one wire end into wire connector
and crimp it.
Step 3 : Insert the second wire end into wire con-
nector and crimp it.
Step 4 : Set the connector in the middle of the
tube.
Step 5 : Shrinking can be accomplished through
the use of a thermo gun or flame torch with a utility
head or other broad flame. Begin at one end of
tubing. Keep tubing out of direct contact with
flame. Keep flame moving back and forth.
Step 6 : Progress toward other end as tubing
shrinks and wrinkles
disappear. Keep the flame moving. A small amount
of glue should be
visible around the ends of the tube.
Step 7 : Let tube to cool before pump installation.
Step 8 : Put together all splinced wires and use
electrical tape to cover the complete heat shrink
from beginning to end.
2190 Boul. Dagenais West TEL: 514.337.4415
LAVAL (QUEBEC) FAX: 514.337.4029
CANADA
H7L 5X9 [email protected]
INSTALLATION
INSTRUCTIONS
MODEL
150143
150152
HEAT SHRINK
SPLICING KIT
Please read these
instructions
carefully. Failure
to comply to
instructions and
designed
operation of
this system,
may void the
warranty.
 2001 BUR-CAM Printed in Canada 140502
1
2
3
4
5
6